Sun. May 22nd, 2022

Caliper Guide Pin Torque. 3 install the caliper guide pins and tighten to specification. To steering knuckle attaching bolts (fig.

Disc Brake Caliper Bolt or Pin Dorman HW14915 Walmart
Disc Brake Caliper Bolt or Pin Dorman HW14915 Walmart from www.walmart.com

Replace the two bolts you removed on the caliper. With the wheel secured, lower the vehicle back to the ground. Install the rear brake caliper with the slide pins.

Torque The Bolts To Your Manufacturer's Specification.

Torque the slide pins as follows: Place the wheel back on the cherokee, and tighten the lug nuts appropriately. Replace the two bolts you removed on the caliper.

Remove The Brake Pad From Brake Caliper Or From Brake Carrier.

Lots of manufacturers loctite these bolts from the factory. Brake caliper bracket bolts (1) and tighten to 190 y (140 lb ft). Your dealer can pull the specs from the service manual.

Caliper Guide Pin Bolts Typically Need A 13Mm Wrench To Remove.

80 ft lbs front and rear for the caliper brackets. 26 ft lbs for the front caliper bolts with akebono calipers. Torque of 19 n·m (192 in.

I Went Ahead And Purchased A Haynes Repair Manual.

Caliper guide pins f & r: Front brake caliper bracket bolts are 129 ft lbs. Other specs are front bleed valve 115 inch pounds , rear bleed valve 62 inch pounds.

According To Gm, The Front Caliper Pin Bolts Are 70 Ft Lbs And The Bracket Bolts Are133 Ft.

2006 escalade awd w/ jet performance parts, afe dry performance air filter and airaid mit intake diablo sport tuned to increase performance. Over torquing the caliper guide pin bolts: Application torque(nm) torque(ftlb) notes brake caliper bleed nipple 5 3.685 front brake caliper mounting bolts 28 20.636 front brake caliper pad retaining pin 18 13.266

By

Leave a Reply

Your email address will not be published.